Ciudad de Mexico:

Research & Development

Our research & development department operates with the goal of extending tool lifetime and improving the quality of the final products.

  • Test developed on materials for die-casting along with Politecnico di Milano – sede di Lecco.
  • Mould design to reduce thermal fatigue (main reason for the wear of the moulds), allowing more effective thermoregulations. This approach, named «puzzle tooling», has a positive influence on the quality of the parts and cycle time.
  • Use of the «vacuum technology».
    Methods developed to measure the effectiveness of suction systems employed and consecuent optimization of its geometries.
    Goal: to limit dimensions of air suction systems, given the same amount of sucked air.
  • Close attention to new technologies.
    We run tests with all the 3D printing technologies (suitable for die-casting) and we use them to improve our knowledge.

HORIZON 2020 program

Co.stamp was honoured by the European Community with the Horizon 2020 for the «puzzle die» project.


The main goal of this project is the development of a software that allows a mould design that lasts longer.
This can be achieved thanks to a new approach of the design phase, which already allowed us to reach satisfying results.

Visit the Horizon 2020 website